IMG_0924

Winding Stem Blank using a Horia Lathe and Motor

So now we were finally able to make a winding stem, well a winding stem of sorts, using the Horia lathe and motor. It wasn’t a complete stem as it lacked a square, slot, thread and a burnished pivot. It was also rather large in size relative to a functioning winding stem. For this exercise […]

313311_304171056274995_100000463103002_1208695_270197223_n-2

Filing Squares

The last exercise to complete before we started making the first winding stems was to perfect the art of filing squares. We had to make a set of 5 squares with the last of the set being just 0.60mm in diameter with a tolerance of +/-0.03mm. This would be the start of very small tolerances […]

IMG_0784

Steeltech Quartz Repair for my Brother

My brother had this watch lying around in a drawer as it had stop working and a new battery hadn’t fixed it. I asked if I could take a look with a view to getting it working again. I popped the back off and disassembled everything… I discovered a cheap Seiko Hattori quartz movement that […]

IMG_0252-2

Tag Heuer 2000 Automatic Project

I purchased this watch from eBay as a water damaged model that was deemed beyond repair. I disassembled the watch on receiving it and discovered extensive damage that explained the ‘deemed beyond repair’. I decided to leave any work until I started at the school when I would source some parts for it. Before… With […]

Lathe Exercises

We had now completed the first part of the course so out came the Horia lathes that we would be using for both of our micro mechanics exams, albeit with a motor instead of a hand wheel. Both exams would be in February so we had a lengthy amount of time to prepare but the […]

IMG_0693

Acrylic Barrel Closer

After quite a few projects completed by hand we were finally able to get to grips with the Schaublin 70 Mi-CF watchmakers lathe. We were tasked with making a barrel closer and although we will not use this until much later on in the course, I’m sure it will prove to be very useful. We […]

IMG_0697

Steel Cube

This would be our final filing project before we moved on to turning on the lathes and ultimately our micro mechanics exams. When we first started at the school we were told by the current second year students and last years graduating students that the cube was extremely difficult. So from the very start this […]

Brass Gauges, Steel Tri-Square and Steel Flat Gauge

Our next 3 projects all involved mastering our filing skills and also moving to a material thats slightly more difficult to work with, steel. The Tri-Square and Flat Gauge have proved invaluable in our subsequent projects and exams. The brass gauges were made by drilling a hole in piece of steel and then cutting straight […]